Precautions in knot tying process of wear-resistant ramming materials

There are many steps in the whole process of abrasion resistant ramming material, and knotting is a relatively important process. And the process of knotting can also affect the service life of the furnace. What should we pay attention to in the knotting process, in order to ensure that does not affect the life of the furnace?

1. The basic of course is the standard operation process, but in addition, in the process of knotting abrasion-resistant ramming materials, there are many matters needing attention. For example, before knotting to ensure that the power supply and water supply system is perfect, but also in advance through the various projects above the staff prepared in advance. Of course, it also includes staff are not allowed to carry any combustibles on the job site, of course, including mobile phones, keys and other items.

2. Sanding in the process of abrasion-resistant ramming is a relatively strict process, such as sand must be one-time enough, do not add it in stages, of course, when adding sand to ensure that the sand lay flat on the bottom of the furnace, can not pile up a pile, otherwise it will cause the size of sand separation.

Tamper

3, when knotting, we should operate according to the way of shaking first and then vibrating. And pay attention to techniques to ensure that the process of operation should be light and heavy. And the rocker must be inserted at the bottom once, and every time the rod is inserted, it will shake eight to ten times.

4, after the bottom of the furnace is finished, ensure that it can be placed in a dry pot smoothly. Only in this way can the standard of forming and comparison be ensured. Of course, there are still many steps to be noted in the whole knotting process, and each step can not be ignored.